Hi,
I have three blocks in my survey but only one will be presented to each participant. Therefore I used the randomizer, stating to present only one out of three. However, the estimated response time and the progress bar do not take that into account. The estimated time response shows the time needed to answer all questions (out of all three, not just one block) and the progress bar skips immediately to 66.66% after the introduction (because it takes the two other blocks into account).
Is there a way to change this?
Thanks a lot!
Page 1 / 1
For more information check this link.
@Paula_Ko210 ,
with addition to what akshay has said,
if you can also do following using randomizer,
create three flags and set it to 0
and check below attached screenshot..
!
with addition to what akshay has said,
if you can also do following using randomizer,
create three flags and set it to 0
and check below attached screenshot..
!
Thank you very much for your help!
If I select "exclude from progress bar calculation" the block that is actually the one presented will be excluded, but I would like to exclude the other 2 blocks which are not presented to the participant. How can I exclude those and only take the presented block into account for the progress bar?
Thanks again!
If I select "exclude from progress bar calculation" the block that is actually the one presented will be excluded, but I would like to exclude the other 2 blocks which are not presented to the participant. How can I exclude those and only take the presented block into account for the progress bar?
Thanks again!
https://community.qualtrics.com/XMcommunity/discussion/comment/5620#Comment_5620hi, I followed your instruction. But the survey automatically skips all questions
Leave a Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.