Good afternoon XM Community,
I am moving from a different platform for surveys, yet cannot figure out the answer to my question, even after searching this amazing community.
I have my survey setup with two (2) attention checks; one IMC and one nonsensical question. I want to terminate the survey if both are missed. I can add scoring to each question, yet do not know where or how to have XM send them to a terminate page if both are missed.
Suggestions? Thank you in advance for any guidance.
JDM
Solved
Branching or Skip Logic after two missed attention checks
+3Best answer by CarolK
Hi jdmill51 - I think what you want is to go to the survey flow, and then at the next block break after the second attention question is presented, add a branch with logic that basically says, If Check1 is not correct AND if Check2 is not correct: and then place a survey end step under that branch.
You can also Customize the end step for those being screened out if you want them to see a different message than "complete" responses and/or if you do not want to save/want to screen out these respondents entirely.
+46Hi jdmill51 - I think what you want is to go to the survey flow, and then at the next block break after the second attention question is presented, add a branch with logic that basically says, If Check1 is not correct AND if Check2 is not correct: and then place a survey end step under that branch.You can also Customize the end step for those being screened out if you want them to see a different message than "complete" responses and/or if you do not want to save/want to screen out these respondents entirely.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.