I have a little introduction statement at the beginning of my loop and merge block. I want it to only show the first loop and not the second loop. I can't figure out which display logic I need to use to only get it to show the first loop. Any help is greatly appreciated. Thank you!

Hi there, To do this, you can go into "Display Logic" for the question you only want to show on the first round. In the Display Logic menu, select "Loop & Merge" from the first drop down, then select "1: ..." then is "Current Loop". Here's an example from a loop & merge I have (your 1: won't have "the ${e://Field/Delay..." after it though):

Loop and Merge | Experience Community

Sign up

Login to the Community

Scanning file for viruses.

This file cannot be downloaded