I setup a 3 concept survey where the user will only see 1 concept. I need to balance the Concept seen by certain criteria. To simplify, I would need each Concept evenly distributed by Age and Gender. I setup Quota buckets Concept 1 Male 18-29, Concept 1 Male 30-39, ext.. and then again for Concept 2 and Concept 3. I then chose the Multiple Match Handling least filled to select 1 of the concepts. I'm trying to take the selected Concept in the quota and set it in Embedded Data but one Choose quota i do not get any options showing which was selected. Any ideas?
Thanks
Page 1 / 1
Hi MacTR!
I'm not entirely familiar with this set-up and what's needing to be accomplished, but perhaps it would be good to set the embedded data values separately from the Quotas, but still using the same logic that assigns them to the Quotas.
If this is not going to be possible, I'd recommend reaching out to Qualtrics Support to take a closer look!
Leave a Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.