Hi, I have three blocks in my survey but only one will be presented to each participant. Therefore I used the randomizer, stating to present only one out of three. However, the estimated response time and the progress bar do not take that into account. The estimated time response shows the time needed to answer all questions (out of all three, not just one block) and the progress bar skips immediately to 66.66% after the introduction (because it takes the two other blocks into account). Is there a way to change this? Thanks a lot!

Hii @Paula_Ko210 , Refer these images..!!

@Paula_Ko210 ,with addition to what akshay has said,if you can also do following using randomizer, create three flags and set it to 0and check below attached screenshot..!

Randomizer - fault in progress bar | Experience Community

Sign up

Login to the Community

Scanning file for viruses.

This file cannot be downloaded