I need a team of inspectors to visit various address and fill out a report using a Qualtrics survey. The address are stored in a drill down questions, 3 deep, once the inspector selects the route and enforcement zone they can pick a address.
Is there a way to remove addresses from the drill down that have already been inspected as each address should only be visited once?
Page 1 / 1
Not using native functionality, I'm afraid. I was thinking you may be able to set up a Quota for each site, but there's no way to use native display logic on the drill-down choices. You'll likely have to request some custom code.
You could set up an email action to be notified each time an inspection is submitted and then go in and edit the list of available choices (personally, I would not remove those choices, but just disable them using impossible display logic). It's manual, but if you're highly concerned about error, it would reduce it.
Leave a Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.