The first question in my survey is a constant sum question where the total automatically calculates and displays at the bottom. Then throughout the survey, I would like to apply the following logics based on the total from that initial constant sum question:
(immediately after the constant sum question)
Skip a few questions ahead in the survey if the constant sum total = 0
(later throughout the survey, some examples include:)
Display a question only if the constant sum total was = 2 or 3
Display a question only if the constant sum total was greater than 3
Display a question only if the constant sum total was greater than 1
However, when I go to set up the skip and display logics, the only options are with the specific items in the constant sum question, not the total. Can someone please help me figure this out?
Thank you very much!
Page 1 / 1
You can create an embedded data variable (in survey flow) after your total sum question, and set that variable to the total sum. Then use the embedded variable for branch and display logic.
This worked perfectly. Thank you very much!
Leave a Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.