Hey all - Quick question.
In the data and analysis tab, once I've filtered my data to get to the responses I want to download, I go through the process of downloading, yet none of my filters hold and I end up with my entire dataset.
How do you make sure your data filters are applied to the download?
Thanks!
Page 1 / 1
I've run into this issue when using the Legacy Exporter. However, when I download just the CSV data table, I'm able to download only the filtered responses.
Thanks so much - just tried this and it worked.
However, I know we've been advised to use the legacy format due to zero filling issues - the majority of our projects do run into the zero filling issue, so I'm also curious as to if there's a solve there too?
However, I know we've been advised to use the legacy format due to zero filling issues - the majority of our projects do run into the zero filling issue, so I'm also curious as to if there's a solve there too?
> @RachelTHREE said:
> Thanks so much - just tried this and it worked.
>
> However, I know we've been advised to use the legacy format due to zero filling issues - the majority of our projects do run into the zero filling issue, so I'm also curious as to if there's a solve there too?
You could download both legacy and non, then filter down to only those in the smaller data set. This uses the corrected data, and gives you easy access to a filtered set.
> Thanks so much - just tried this and it worked.
>
> However, I know we've been advised to use the legacy format due to zero filling issues - the majority of our projects do run into the zero filling issue, so I'm also curious as to if there's a solve there too?
You could download both legacy and non, then filter down to only those in the smaller data set. This uses the corrected data, and gives you easy access to a filtered set.
Leave a Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.