Output based on comparsion of embedded data values

Question

Dear community members, I would like to ask you for advice regarding the possibility of comparing embedded data values.I have several numeric embedded variables (e.g. NT1, NT2, NT3, NT4). For future use, I need to compare the value of these variables respectively used following logic in the "branch element" or/and in "the display logic". The logic I need to use is "Display question"/"then branch if" the embedded data NT1 > NT2 AND > NT3 AND > NT4. I'm right that the conventional way of writing an operator into branch element or display logic expects the numeric value after "is greater than"? So, the picture below is probably nonsense? Consequently, my question is: Is there any way to put the order I mentioned to branch element/display logic? I'm also thinking about evading this problem, and this is my second question. Is there any possibility of creating an embedded variable with a specific value as a result of comparing the source embedded variable's values? For example, (new embedded variable) NTT with value 1 if the embedded variable NT1 > the embedded variable NT2 AND > the embedded variable NT3 AND > the embedded variable NT4.Thank you a lot for your answers.

ahmedA · Accepted Answer

https://www.qualtrics.com/community/discussion/16614/output-based-on-comparsion-of-embedded-data-valuesThe text in the field after greater than or any other condition is interpreted literally. So you'll need to use the format for piped text like {e://Field/NT2} etc. otherwise your values will be compared to NT2 and since this will throw an error nothing will happen.

Eumetis · Answer

From what I understood you're asking if the logic shown in the pic can be put into the display logic/branch logic such that the next question should be shown only if NT1 > NT2 AND > NT3 AND > NT4 is true? Cause what you've written in the branch logic is correct but if you'd have to put that into the display logic of the question you want to display ORYou could do the followingFirst, create the embedded variables and assign them their values (NT1,2,3,4) and place them at the top of the survey flow.Write the branch you want then assign the value to the ntt as one inside the branchPlace the block of question you wanted to display based on the branch inside the branch.

Sign up

Login to the Community

Scanning file for viruses.

This file cannot be downloaded