Hi everyone,
I am trying to create a Loop and Merge.
I start asking what products you use: A, B, C, D, E, etc. (list of +10).
I would then proceed by asking a series of identical question to users of a specific product (based on the question above). Loop and merge comes handy.
Can I set the Loop&Merge only on a specific subset of selected answers? Like only to those who have answered C, D, E. When setting L&M (based on question) it would automatically pick potentially all the selected answers. Can I choose a specific subset only?
This is because I would like only to collect data for certain selected choices only. Setting a number of L&M times with randomization doesn't work well for this case. Are there any other tricks? Tried setting a static L&M with Display Logic (show if C selected or D selected or E selected) and embedded LM text but it doesn't work, as people will have the whole static L&M shown (C, D, E) even if they just use C.
Thanks for the help.
Hope it was clear-
Rob
Loop &Merge based on a question and "sub-selection" of Selected Answers
Best answer by ElieD
Hi Rob,
I prefer survey flow than display logic so this is my proposition for you, without loop and merge :
First, group your questions in blocks and identify witch block will be asked for each product.
Then add a branch for each product and set an embedded data at the beginning of block so you can use it as piped text.
After that, you will just have to copy your blocks for each product where it applies
Look at some illustrations below,
Élie
---
The questions blocks :
And the survey flow :
+39Hi Rob,
I prefer survey flow than display logic so this is my proposition for you, without loop and merge :
First, group your questions in blocks and identify witch block will be asked for each product.
Then add a branch for each product and set an embedded data at the beginning of block so you can use it as piped text.
After that, you will just have to copy your blocks for each product where it applies
Look at some illustrations below,
Élie
---
The questions blocks :
And the survey flow :
Hi! I'm also looking for a solution on looping a block based on a subset of choices from a multiple-choice question.
The advised solution that uses survey flow is not good enough for me, because I want to loop a multiple choice question with randomized answer order and this order should be the same for all looped cases .
I have experience with Alchemer, in which it's very easy to create a hidden variable that captures only those answer options for which I want to enable a loop, and I can build a looping logic on that hidden variable. Is there anything similar possible in Qualtrics? I.e. creating a hidden mulltiple-choice variable for only relevant answer options and feeding it into the looping logic?
Leave a Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.