Hi all, my first question here.
I have created a survey for supplier evaluation.
The Flow is similar to below
Block 1
- Question "Select Vendor(s) to evaluate"
Block 2
- Set of 10 questions w/Loop $ Merge from Block1
- Set of 6 questions (valid only for some suppliers) w/Skip Logic based on Block1
Block 3
- Question "Did you finished or you want to evaluate other suppliers?"
No I would like that when Question in Block 3 is Yes-Finished, the Survey will ends.
If the question instead is No-I want to evaluate others, the flow will go back from Block 1.
And I would like that only "remaining" suppliers not already previously selected will be shown for selection.
All of this until the customer will thick Yes-Finished.
Any idea to support?
Thank you.
Antonio
Solved
Survey Flow - End of Survey or start from square 1
Best answer by Kate
That makes sense to me, @Antonio! I would add that you need to remember the flow is linear. You can reference the customer back to their work on Block1, but know that you are going to have to make that happen a finite number of times. There is not a way to create a continuous loop back to Block1- you need to build it into the linear flow a finite number of times.
View originalLeave a Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.