Solved
Different sample rate depending on embedded data
+4Hi!
I have a SI which has 15% sample rate. But for my german speaking visitors, I'd like to have 30% sample rate. I know Qualtrics captures browser language via Q_language. Does that mean my only option is to copy the SI and make a different sample rate but where this as additionally requirement that Q_language is = DE and the original one goes != DE?
And does Q_language actually gets captured upon the refresh of the page or when the feedback/response is given? This above solution would require that the Qualtrics code already nows the Q_language to then decide if it should show by the 15% or 30% rule.
Thanks
Best answer by AbdulDezkam
After some talks with support, we found a solution.
The site intercept overall setting has 100% sample rate. We then use the location display rule in SI to group 2 action sets. 1 for german-speaking countries which will then in the action set itself have 30% sample rate, whereas the rest of the world (2nd action set) will have sample rate of 15%. I did not know one could set the sample rate on action set-level. That's brilliant!
View original+4After some talks with support, we found a solution.
The site intercept overall setting has 100% sample rate. We then use the location display rule in SI to group 2 action sets. 1 for german-speaking countries which will then in the action set itself have 30% sample rate, whereas the rest of the world (2nd action set) will have sample rate of 15%. I did not know one could set the sample rate on action set-level. That's brilliant!
Leave a Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.